NYSEG and RG&E offer rebates to non-residential customers installing energy efficient equipment that have an electricity Systems Benefits Charge (SBC) included in their energy bills. Both prescriptive rebates and custom incentives are available, and can be applied to retrofits, add-ons, major renovations and new construction.
Custom incentives are available when energy efficiency improvements require site-specific engineering and cost analysis. Any nonresidential NYSEG or RG&E electricity customer is eligible, and customers can select their own contractor to install equipment. See program site for further details on both custom and prescriptive rebates.
|Incentive Type:||Rebate Program|
|Eligible Renewable/Other Technologies:||
LED Replacement Tubes: $4 - $18/unit
LED Screw-In and Pin-Based Lamps: $2 - $2.50/unit
LED Interior Ambient Fixtures: $15 - $65/unit
LED Downlights: $15 - $35/unit
LED High/Low Bay Fixtures: $35 - $400/unit
LED Refrigerated Case Lights: $3 - $7/linear foot
LED Exterior Area Fixtures: $60 - $540/unit
Lighting Controls: $3 - $44/sensor
Additional rebates are available beyond air conditioners and heat pumps. See program site for details.
Unitary HVAC and Split AC Systems: $40 - $150/ton
Programmable Thermostat: $75/unit
Condenser Water Pump: $40
Chilled Water Pump: $40
Hot Water Pump: $40
Cooling Tower Fan: $40
Return Fan: $60
Supply Fan: $60
Convection Oven: $500
Combination Oven: $500 - $2,000
Insulated Holding Cabinet: $400 - $800
Ice-Maker: $100 - $800
Dishwashers: $50 - $900
ECM for Refrigeration Evaporator Fans: $20/motor
Process Systems: Varies, see program site for further details
Agricultural Equipment: Varies, see program site for further details
Custom Electric: $0.20/kWh saved
|Maximum Incentive:||No maximum per customer rebate; however, NYSEG/RG&E reserve the right to cap the rebate to any one customer.|
|Eligible System Size:||
Prescriptive rebates listed in this table are available to all non-residential customers of the company who pay the systems benefits charge.
Pre-approval is required for prescriptive applications with total rebate value greater than $10,000.
|Equipment Requirements:||See program for details|
Any applications above $10,000 must be pre-approved
|Technologies:||Custom/Others pending approval|
|Sectors:||Commercial, Industrial, Local Government, Nonprofit, State Government, Federal Government, Tribal Government, Agricultural, Institutional|
|Parameters:||The incentive is 0.20 $/first year kWh savings|
|Name:||C&I Rebate Program|
This information is sourced from DSIRE; the most comprehensive source of information on incentives and policies that support renewables and energy efficiency in the United States. Established in 1995, DSIRE is operated by the N.C. Clean Energy Technology Center at N.C. State University.
Copyright © 2023 EnergyBot • All rights reserved.
1601 Bryan St Suite 900, Dallas, TX 75201